About Ovais Yousuf

Ovais Yousuf · 03-01-2017

Hello All, I have a question regarding the secure registration of a cisco endpoint e.g DX80 over MRA. The codec DX80 is registered from external network over MRA but on Non-Secure Sip Profile. But when I am trying to change the Sip profile to Secure...

Ovais Yousuf · 10-13-2016

Dear All, I wanted to make a secure (Encrypted) call between the registered endpoints with in the same CUCM 11.5.0 I have created a secure Phoone Profile and added them into the Endpoints profile. I have set the endpoint DX80 on TLS as a transport ...

Ovais Yousuf · 07-13-2016

Hello All, I have migrated Cisco DX80 Android based to CE Software version by following the Cisco document exactly. But the device is still not registered with CUCM 10.5.2 I have installed device pack (cmterm-devicepack10.5.2.14076-1.cop.sgn) and ...

Ovais Yousuf · 10-24-2016

Actually the issue i found here is .. Dx80 is not taking the LSC certificate from the CUCM. I am trying to upgrade the CAPF from the DX80 Profile on the CUCM but it is showing " Invalid Credentials " on the DX80 phone Profile on the CUCM. I dont und...

Ovais Yousuf · 10-17-2016

Hi Jonathan, Yes the CUCM is in the Cluster operating mixed mode means the value is 1. I have tried to push the LSC onto the Dx80. but the Problem i dont understand is only one of my DX80 has the LSC certificate but the same process i am performing t...

Ovais Yousuf · 08-02-2016

Hi Chandra, The only issue I found during this whole upgrading process is You need to assign the DHCP to your CUCM if not .. The Dx80 CE based will not be registered with CUCM. Try not to give the static IP to DX80 CE based just click on the dynamic...

Ovais Yousuf · 07-27-2016

Hi Joel, No still and the Problem is as similar as it is yours. UCM is showing unknown and is unable to Show the Active Load: as cmterm-synergy-ce8_2_0_no_defaults.cop.sgn and the DX80 device is also showing that it is unregisterd and with the two s...

Ovais Yousuf · 07-14-2016

Hi Shashank, 1) Is there any way to delete the loaded software installed into the CUCM (OS Administration > Show > Software). I mean i am willing to delete the previous installed Software Options and wanted to install them again. 2) Secondly the fir...

Member Since	‎07-13-2016 07:57 AM
Date Last Visited	‎03-24-2019 10:31 AM
Posts	9

User Statistics

User Activity

Secure Registration/Calling from DX80 over Tls via RMA

SSL connection rejected ( Cisco Endpoint Dx80)

CE Softrware Registration Failed

Actually the issue i found

Hi Jonathan,

Hi Chandra,

Hi Joel,

Hi Shashank,