Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Trying to assign 10.0.0.0 range of IP as management IP for CE 500 switch. as per release notes at http://www.cisco.com/en/US/products/ps6545/prod_release_note09186a00806996e5.html " You can now configure the switch with a 10.0.0.x IP address. In t...
Want to know whether "max-reserved-bandwidth" command is supported on fastethernet/gigethernet interfaces. I am working with 7600 router (IOS, 12.2(33)SRA2) with 16 Fastethernet Interfaces and try to use "max-reserved-bandwidth" command on the Fastet...
Hi,We are trying to configure QoS on 3550 switch L3 interfaces.The IOS running is c3550-ipservices-mz.122-25.SEE2.binWe are facing the following problem1. Trying to configure Policy-Map and Class-Map2. Under Policy-Map when getting into Class-Map con...
we want to manipulate the routes (May be cost) in such a way that one default route is preferred over the other in one area and vice versa in the other area. And in case of failure of one route the second one should be taken.
Hi Swaroop,Thank you.But, may I get some document which can tell that this particular command is not supported with this combination (7600 with 7600-SIP-200 module)? Or something like "this command belongs to particular group of QoS mechanism and so ...
Hi,With Pilot point option, Circular hunting is not functioning and Call Waiting (Multiple Calls Cricularly Landing on the same Line of a phone in the group)also not happening. To fulfill this requirement only, the Line group/Hunt List option is used...
Hi,Thank you for that suggestion. It is presently configured with Line groups and Hunt Lists. Let me change it to the Pilot Point option and try. Let you know the status.Thanks & RegardsSebastian
