Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As far as CallManager Multi Tenant goes, I am good with how to do everything except the directory part. From what I read, I can use the Cisco SDK (editing the XML) to say which directory each phone can see in the Corporate Directory. I'm trying to ...
I am using the Acct code on CME 4.3. Where can I report on these accounting codes? The call history in CME doesn't show them. Do I need to pump them to an outside server via syslog or Radius accounting somehow?Can someone let me know and can you g...
Ok when I push the settings button on a Cisco phone, and choose Network Configuration, I can see all kinds of information (IP address, TFTP Server, Default Gateway, etc). I want my users to be able to access the network configuration but I want to pi...
Ok, All I'm trying to do is find an SNMP OID that tells me how many B-channels are in use on the PRI. I've tried lots of OID's, even ones that are described as doing just want I want them to, but they either come back with a HUGE number or zero.Anyo...
I will try to make this as simple as possible:I have a customer with Unified Messaging and the following need:-- Need to be able to restrict employees from forwarding voicemails to other e-mail recipients (internal or external).---- *NOTE*: This is s...
Please read the original request. I know how to do this kind of thing. I'm more interested in how to block out 1 single thing INSIDE of the network configuration page, not the entire thing.
Stephan, no offense, but I didn't ask if it was a good idea. I don't want this thread to turn this into a question of why I would or wouldn't want to hide anything or if it's a good idea or not.I'm just asking *if* and *how* I can hide certain infor...
I am having the same problem but only when I failover. Everything works fine when I'm on the primary IPCC box (Publisher), but on the secondary (Subscriber) when trying to access this information, I get this error message. I get this error message ...
He doesn't want to do Command Level Authorization, he just wants it to place him directly into enable mode when he logs in with his username and password.Got any idea how to do that?
