Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm not able to find any clear documentation on how to configure Easy VPN Server for ASA5510 using ASDM to connect to a remote router. If i use the IPSec VPN Wizard and go to Remote access configuration, am not sure if it's the same if th...
Hello, I'm trying to setup Cisco 887g-w router with 3G GSM SIM card. We got a data sim card from telco with a static IP address. Below is the some outputs. The cellular interface keeps flapping, but am not able to ping at all to any public ...
hello,I have a Cisco 3560 switch which we found that the speed was set to 115200.So we tried changing the speed to 9600 in config mode and after saving, when we reload it goes back to 115200..So now we go to bootloader mode and set the speed there. s...
hey all,Is there any good attendant console supported by call manager express..basically we wanted the attendant console to work even if our wan link to the callmanager in dc fails...thanks in advance...
hi grant,i tried giving the set boot command in boot loader mode but, it still tries to boot with the old one first...hi mark,i also tried setting the baud rate to 9600 using set baud rate 9600 in boot loader mode...it goes back to the 115200 after a...
Hi Mark,It did not solve the problem. Next reload and it's back to 115200. However i noticed that other configurations are saved without any issues..well i also get this error message whenver booting the switch.Loading "flash:c3560-ipbase-mz.122-25.S...
