Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I would like to try to implement T37 S&F on a 2951. However, my PRI is already binded to an MGCP gateway to CUCM, which means the dial plan will be ignored on any incoming calls, so I can't get the call to the onramp script. Is there a way to ...
Does this make any sense? My core switch (acting as the default L3 for clients) is responding to all arp requests with one of it's own MAC addresses. I can't figure out why. Any ideas?Thanks
Hey guys,Somewhat new to CME. Spec'ing out a small system for 20 phones running off a 2911. I want the 2911 to handle all of the calls, voicemails, basic AA, and do basic IOS firewall for the facility. Phones will be 7942's, and I'm planning on using...
Hey guys,Putting in a 1Gbps private ethernet link between 2 sites. Currently have 2 2811's at each location, don't think that will cut it. I was going to get 2 2911's, but looking at the docs it looks like they can only do 180mbps of throughput? Am I...
Hey guys,I need to implement a VPN backup for an MPLS network (running ibgp). I would like to concurrently run a VPN tunnel from a branch office to HQ alongside a MPLS. When the MPLS goes down I'd like traffic to go over the VPN, but only then. I was...
You probably fixed this by now, but if not, you need to either use NAT on the outbound traffic or (if you have a static with your ISP) put an ACL on the cellular interface making sure only packets with you cellular IP make it out. In your case, it lo...
Thanks for the response Ronak. Seems like one option woudl be to put another VWIC in the router, have CUCM send the call back out one port, to a loopback cable, and back in the other port, configured with no MGCP gateway and Onramp....though I don't ...
Thanks Amer!I think I will be OK with the basic AA, so do I not need any port licenses then? Hopefully that is the case.My IP phone part number, CP-7942G-CCME includes a CME license so I think I am OK there, right?I am going to be using a SIP provide...
Thanks! Again, much appreciated. So what's the best route for me here? Put an ASA on either side of the EPL and run encryption on it (IPSec?) in addition to the 2811's and put 2 prioritized routes in the core switches at each location? Or go with a b...
