Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All: I would appreciate if someone can share their lifetime experience and suggest me to finalize the right product between ASR 1006 or ASR 9001.Requirements:- We need full internet feed with IPv4 and IPv6.-10 G & STM-16 interfaces for connectivit...
I want to configure RMON to monitor tunnel interfaces on Cisco 3845 router.I tried to search but the configuration which i found is not functional on my routers.Can anyone help ???IOS Version 12.4(3g.Thanks.
can any one answer that what this msg indicates? i found this error message on my 6509 switch through syslog. 7201: 1w2d: %MCAST-SP-6-L2_HASH_BUCKET_COLLISION: Failure installing (G,C)->index: (0100.5e5c.c31f,1)->0x806 Protocol :0 Error:3Thanks - Rah...
Hi All,what are the possible causes of Mac-Address Flapping?i have recived messages in my switch for the mac-address flapping ( Mac-Address 0201.0000.0000)Thanks & Regards,Raheel
Hi Scott:I have a query here, I have one AIR-CT2504-25-K9 and AIR-CT2504-HA-K9 with L-LIC-CT2504-5A.Can I use this as Active-Active to achieve load balancing and failsafe environment using 2504-HA hardware ?I have 20 AP's to be managed ....
hello,Thanks for your reply.I had already viewed this document but it is not solving my problem, i have to run rmon on tunnel interface, is there any way out to get rmons traps of tunnel interfaces.rgds, Raheel
NIC's of this server are conected with two diffreent switches.and both switches could not communicate with each other.can you please assist me that how can i configure load balancing.or is there any other solution if anythanx - raheel
