Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I need to urgently upgrade 2 Cisco Unity clusters consisting of 1 PUB & 1 SUB each. I read some of the blogs in forum and also referred other sites for best answers but I am not sure how to proceed with the same. I am doing it first time, so bit ...
Hi,
I have an installation coming up in Hong Kong using a local IDAP circuit. Can anyone share there experience while making it communicate with voice router and further to CUCM. I already have T1 configuration on Voice router, so do I need to modi...
I have a raised a request to the respective team to VMotion the existing VM running CUCM 10.5(2) version from existing host to a new host. So I would like to know about the things regarding CUCM which I should note down or take care before and after ...
Hello,
What configuration I can implement in order to route the incoming calls to CUCM from Lync application via particular PSTN. Suppose I have two set of extension range i.e. 911206118XXX and 9112061197XX but I want if the calling from number is 9...
Hello,
In Webex to join the meeting we use "call me or Call Using this computer" feature so that audio can be enabled, so to do that does it use data network or goes out via VOIP network configured within company ?.
Actually, in my company we are ...
Hello Chris,
I also resolved the same issue by un-checking the UP on TP. I have 9.0044! TP that has Pre dot configured.
With Urgent priority checked > When I dial 9004420, when I enter 7th digit, it then says call cannot be completed.
Urgent prio...
Hello Jaime,
Yes trying to understand the process by reading the guide. Just to cross check as I am not sure because of multiple statements, to upgrade from 8.5.1 to 8.6.2 I do not need to run COP before upgrading ?. I can straight away install IOS...
I read the steps explained by him and found it it helpful but after doing some research I found that my existing hardware doesn't meet the RAM requirement.
I will need to upgrade the existing 4 GB RAM to 8GB on my hardware platforms i.e. Cisco 7845H2...
Thanks for the link mate. I understood the VM requirements but I would like to know that is there any pre/post check list that I should prepare before/after existing VM is VMotioned to a new host.
There is a way to do so, under TP you can use option "Route Next Hop By Calling Party Number". Please refer https://supportforums.cisco.com/document/71966/blocking-calls-based-calling-party-id, it explains the process. Its a very tricky one and not r...
