Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, something's going wrong with dot1x auth of some win10 802.1x clients. This is how the NAS port is configured:
interface GigabitEthernet1/0/5
authentication host-mode multi-domain authentication port-control auto authentication violation p...
Hi All, just wanted to know if something has changed regarding the possibility to establish GRE tunnels specifying HSRP addresses as source/destination of the tunnel. I read several old posts where it was defined as not possible, or people discourage...
Hi All,I have a problem with dtmf translation in my voice gateway.This is the environment:Cisco Call Manager 4Cisco 2821 IOS Voice GW - Version 12.4Phones registered to CUCM via SCCP (Cisco 7960, 7970)ISP SIP Trunk offering SIP-INFO as DTMF The SIP t...
Hi everybody! I go straight to the problem I'm facing:I need to send a data stream via RSPAN to a remote device for traffic analysis. Because of the large amount of data (>1Gbps) I need to put the remote VLAN, which carries the RSPAN traffic, on an e...
Hello Mohammed, thank you for your answer. What do you mean with "LDAP to ACS"? My situation is that I already joined and connected to an AD server that I use for user authentication on RADIUS/TACACS services. I would like to know if I can also use t...
Actually, when the problem arise, no mac address is shown in the interface:
# show mac address-table interface Gi2/0/7 Mac Address Table-------------------------------------------Vlan Mac Address Type Ports---- ---------...
Actually no mac address is shown on the switch interface.
The NIC is an Intel I218-LM and the issue arise randomly not only when recovering from standby status but even when a user only disconnects from his account.Looked for bugs related to this iss...
