Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just got 2 new CSR8000V. They connect to our existing ITSP but will handle a new number range (just one number in config presently.) On CUCM the 2 new trunks are up using same config as the old pair of trunks for the older CSRsI've created a sin...
Hello,We seem to have got into a bit of a mess with respect to licenses and actual usage. The license report tells use everything is good, but is overstating our actual usage with respect to users. The problem is that CUCM thinks that <user> should h...
Hello, I just tried to move half of our Expressway cluster to new ESXi hosts as the old hosts are rapidly approaching end-of-support.
I read in the X8.7 VM install guide: "If you need to move Expressway to a new host you must perform a host migratio...
I'm not going to deny that! I'll finish my config, tidy up the mess that I've made along the way (mostly on the SBCs) and will then try to get a coherent message put together for our support partner to see what they make of it and escalate if they ne...
Thank you to everyone that chipped-in here. It's really quite challenging to spot a problem in config like this, especially from afar, but it's now resolved as of about an hour ago. The problem was on the CUCM trunk. We've got 2 'old' CSR8000v and 2 ...
Apols for the delay in reply. CUCM Trunk configSBC03 Trunk config:interface GigabitEthernet1 description *LANSide SBC03 to CUCM* ip address 10.42.18.104 255.255.255.192 ip nat outside negotiation auto no mop enabled no mop sysidDial peer to a subdial...
Second post of the day for my thread. Here's the SBC output of my failed call. Correct outbound dial peers matched in debug dialpeer output. Tries both of those subscriber destinations. Gets a 404 for both. Then a final 'No outbound dialpeer message'...
