Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have CUCM 7.1 with remote branches connected via dedicated T1 (MPLS). Cisco 2621 and 3560 at branches with Cisco 7940 and 7941 IP phones. Two branches have had brief power outages after which very few of the phones will register once power and th...
I've got a warehouse with two 1131 access points, one of which is configured as a wds. a tablet pc running xp tablet os is the only client. the tablet will associate with either access point (one or the other) upon startup but loses association while...
I had this same issue come up and for some it was sporadic (me), but for the user who reported it the screen capture always failed.As a result of contacting our webex connect support, installing two certificates on machines on each end of conversatio...
Thanks Marcel! I've attached the most recent console log from one of the phones, and also the device information from the phone url which should cover the firmware and other pertinent information.
We actually decided to remove one of the two access points and move the other to be more centrally located. I would have still posted the wds config but the ap was set back to defaults. Thanks for the reply though!
