Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,Can someone just double check my thinking? I've been asked to enable VTP over an existing network (rather than remove which I'd expect...) with a number (20ish) VLANs that are to remain unchanged. I'm thinking...Visit each switch and note VLAN nu...
All,How do I backup and restore the config in a WiSM? I thought this would be easy to lookup, but so far no joy!I assume I just shut the module down, pull it out, push the new (with the chassis still up) it's just the backup/restore I'm unsure on.Che...
Hello All,A quick question... just as I can use custom URL categories to whitelist WWW sites or exempt them from authentication requirements, can I do the same with FTP?If I want to allow people through the TFP proxy to, for example, fto.redhat.com d...
Hi All,It's been a little while since I deployed a WSA and I see a new tool, the Active Directoy Agent. I understand from the docs it's used to get usernames from AD for the current logged on user when using NTLM authentication for transparent auth.M...
Hello All,I've trying to customise my SSL Portal from the usual place in the ASDM:Configuration > Remote Access VPN > Clientless SSL VPN Access > Portal > CustomizationHowever, when I click "Add" to create one (I have only the non-editable default "T...
So, if there's WCS/NCS simply replacing the physical unit and updating to WCS to know of the new MAC that's it and a restore can be performed from teh WCS?I assume when you say double check the etherchannels those are the channels the chassis uses to...
Fixed it!From the command line:revert webvpn allTo reset the webvpn config. I don't know what it didn't like as this was a fresh box. But doing that has enabled me to create my cusomisations.
