Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a Cisco ASA running 8.4(3) which we have setup with a Cisco ACS 5.3 server. We've got the attribute 25 mapping working, but there are some instances where I would like the group policy sent in the class attribute 25 to be overridden by the...
Hi,Does anyone know there is a command that would bascially mean "ip icmp source-interface"? I know of another commands like this "ip tftp source-interface" or "ip ftp source-interface" that will allow you to source specific services from a specific ...
We have 1 x 3020 concentrator and 1 x 3005 concentrator, both currently use ACS 3.3 for authentication and we make use of the IETF attribute 25 to map user into specific concentrator groups on both the 3020 and the 3005 without any problem. The conce...
Hi we run 2 x CSS11503 with box-box redundancy. I have configured both management ports with IP's and default gateways. The management ports work fine when the box is in "master mode" but as soon as it goes in to "ackup mode"I loose connection to the...
Hi we are currently converting our network from Frame-relay/OSFP to MPLS with e-bgp. We are redistributing the MPLS e-bgp processinto OSPF. We want to leave the OSPF frame network in place as a backup for the time being. The problem I face is that th...
Hi, I'm having the same issue issue in 12.2(55)SE6 IP services, did you ever get it working or find a work around?Web-Auth-TestSW1(config-if)#int fa3/0/1Web-Auth-TestSW1(config-if)#no swWeb-Auth-TestSW1(config-if)# ip address 10.x.x.x 255.255.255.12...
Hi Giuseppe,Thanks for the reply, the script is a pearl script that runs an SNMP mib to invoke the ping request, hence we do not have access to the source option in the command you mention, which was why I was wondering if there was a way to change t...
We managed to get this problem sorted in the end. To get the spectrum 24 card to connect we had to tie the 1230 AP down to a specific channel instead of the default "use less congested channel" option.
