Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:Is it possible (and a good design to avoid layer 2 loops) to combine the stp and protected ports features on uplinks ports of an edge "non-transit switch"?The uplinks ports that i would like to have also as protected ports will be dot1q trunks, an...
I've seen the cisco doc about how to configure multiple RPs with AUTORP and to have a different range of multicast groups assigned to each RP, but i don't understand totally how the acl you apply to do so works. This is, to do so you use in the conf...
Hi all, We are also having this issue, please can anyone comment if is it solved using Cisco workaournd? We tried it, but problem persistsKind regards, Juan
Hi Kumar,
This is the most extrange, interface 1 in module 1 is not connected to anything... i suppose it is a bug , but it appears suddenly, device is working fine without alarms several years ago
Regards
Hi Kumar,
Hi,
Only diagnostic result that is not OK is this one of module 1 :
13) TestUnusedPortLoopback:
Port 1 2 3 4
----------------
F . U .
Error code ------------------> 45 (DIAG_CHECK_ETHER_...
