Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all
I've recently purchased a ATA191-3PW-K9 to work with an existing analogue phone. I want to set the IP addressing up so it can connect to my network, however I can't seem to be able to access the webpage via it's default IP address
From read...
Hello all,
I have a Cisco VG450 Voice Gateway with NIM-4FXO cards. I am interfacing to a PABX via copper and have an interface issue.
After some tweaking to sort a previous issue where an incoming call ringing cut out after less than a second (resolv...
Hello all, I have a Cisco ASR920 and upgraded the IOS. Since then I have noticed the following message appear:%IOSXE-2-PLATFORM: R0/0: kernel: [ 1736.546538] EXT2-fs error (device mmcblk0p1): ext2_lookup: deleted inode referenced: 159247 Any idea how...
Hello all,I have an issue that has got a lot of us stumped regarding multicast and need some support. Specific multicast configs from the equipment (includes 'show ip route' & 'show ip mroute') and a topology of the network are attached. We have a mu...
Hello all, I have a Cisco VG350 which has one of its FXO ports connecting to another PABX which is configured as a hotline (ie. has no digit matching/route pattern in it's config, it just looks for a loop on the line then routes the call). The intial...
Hi
The PABX is a Mitel MXOne
I could try ground start instead of loop start and see what happens. I don't have any control of the MXOne so I need to make the necessary tweaks on the VG450 to get it working which means using an FXO port
Anyone with any ideas please?
I found the below fourm thread, is this worth investigating or is this a different issue altogether?
https://community.cisco.com/t5/ip-telephony-and-phones/fxo-disconnect-problem-again/td-p/1700180
I solved the issue, it was down to a corrupt bootflash. If anyone else had this issue I followed the below procedure: Take a ‘show run’ of the ASR920 configInsert a USB stick into the Cisco ASR920 (usb0:)Copy the IOS from flash: to usb0:Format the bo...
Hi @Roger Kallberg I can confirm adding 'NANP PreDot' on the RG config has solved the prolem! I still don't understand why PreDot on the RP didn't work but PreDot on the RG does, I would've thought the SIP reply to the SIP phone would take place aft...
Hi @Giuseppe Larosa I can confirm I now have multicast end to end. I solved as follows: Changed from HSRP to OSPF so more like a traditional campus networkManually configured 'ip pim rp-address 192.168.1.74' to each L3 device Thanks for your help wi...
