Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!We have an old UCS system that had been unused for two years. When we tried to brig this old system up, the Fabric Interconnect switches did not boot up correctly. Both switches acted similarly; all ports on both switches remained orange.HAs anybo...
Hi!I changed compactflash cards on one of our cisco 2801's powerconnected trying to get a 512MBcard partitioned to 128MB to work, and when I Installed this 512MBcard, router droppedsuddenly to rommon. I Switched power off and tried to boot withorigi...
Hi,I installed ACS on a domain controller server. After the installation, the console requires a administrator username and a password. I tried to enter my local administrator loggin but it tells me "login fail... Try again". As during the installati...
Hi!I have to site A and B connected by Site to Site VPN and they areworking OK. When I try to add remote access VPN for Site A so thatusers at home could use Both site A´s ja Site B´s services and alsoconnect to net through site A, I can't get this ...
I can Boot router with image from flash, but my router hangs after "Installed image archive" prompt. Actually we have three 2801:s with similar problems. TFTPNDLD command from rommon has following output:rommon 11 > tftpdnld IP_ADDRESS: 192....
Actually, I did follow the installation guide step by step and create the specific user CSACS that ACS would use as an account. But when I have to define the services to log on as CSACS and restart the services, it is impossible. Where could that com...
