04-11-2005 05:48 AM - edited 02-21-2020 01:42 PM
Hi!
I have to site A and B connected by Site to Site VPN and they are
working OK. When I try to add remote access VPN for Site A so that
users at home could use Both site A´s ja Site B´s services and also
connect to net through site A, I can't get this to work. I have tried doing this both with PDM and commandline. I have quite a lot experiece with routers, but PIXes are still somewhat mystery to me. Does anyone have any similar working configurations to share with me?
Any help would be greatly apreciated
Marko Uusitalo
04-11-2005 08:23 AM
This might help. You could post your config after removing the password lines and any outside ip address information
04-11-2005 04:42 PM
I quiet sure that this will not work, because the PIX does not support spoke VPNs in PIX OS 6.3.x.
This means you cannot connect with the VPN Client to PIX A and then via the same interface connect via another Tunel to PIX B.
This feature was added to PIX OS 7.0.
sincerely
Patrick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide