Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to get a grasp of how t.37 Off Ramp faxing works. We have OnRamp working fine, where by a dial-peer is matched to an incoming fax number and passed to a mailbox. How does it work in the reverse?If I put FAX=123456789@fax.mail.com i...
Hi there, we would like to explore the idea of having the 3800 handel out going faxing. Currently it has dial-peers configured to capture incoming faxes, how do we do it for out going? E-mail to a fax number? Scan to a fax number?? What format does i...
I would like to know what the pros and cons are having MeetMe services on Call Manager (v6.1.3) versus the function on a Cisco 3800 router. (I know the 3800 has a limitation of 100 concurrent users, but thats about it!) ***CCMMaximum MeetMe Conferenc...
Hi, I would like to know the limitations of our system, from what I understand Meet me has a built in limitation of max 100 concurrent users.Our 3800vx GW shows - max-conferences 6 gain -6CCM 6.1 - Maximum MeetMe Conference Unicast of 20Is there not...
Not so much a problem but a question. I'd like to create multiple ether channels spanning across two module blades - 4 interfaces per blade to a single server (8 interfaces in total), how would you recommend this be configured? If one blade goes down...
Hi, you may be able to help me with understanding how this all comes together. When sending FAX=123456789@domain.comhow does the SMTP server know to relay this address to the router?Thanks for yoiur help.
Thanks for the reply,Is there a how to setup t.37 for dummies? application ! service fax_offramp flash::app_faxmail_offramp.2.0.1.1.tcldial-peer voice 8888 mmoip information-type fax incoming called-number 9123456789 - I don't understand this part, w...
OK thanks for that, so from our configuration, we are using a mix of both? CCM handles all g.711 traffic and when another codec is presented say g.729 the 3800 takes over doing the transcoding?Thanks again, most appreciated!
