Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,I have a Cisco router that works as a VPN server. a remote user uses Cisco VPN client 5.0.05.0290 to connect to the office resources. Every one hour (or a few minutes less than one hour) after a connections is established, a message pops up on ...
Hello,I am getting a lot of reassembled packets on a busy router. is there a way to see what those packets are. I need to know the source/destination IP at least. I do not want to impact the router's performance either, as it routes about 5000 pps. t...
Hi,we have two remote sites connected to each other using a GRE tunnel. I wanted to apply a QoS policy to ensure two video cameras can have at least 400kbps bandwidth available. When I apply this QoS policy to the Tunnel interface I am getting error ...
Hi,I need the following:I have Ethernet0/0 with 192.168.5.0/24 on the router that has two WAN circuits, MPLS and IPSEC'ed gre tunnel. both wan circuits go back to corporate. I have bgp running across MPLS and EIGRP across gre tunnels. GRE tunnels are...
did you issue the "card type" command?card type t1 0 1 for example. you need to tell the router what type of the interface you want it to be - T1 or E1
Aaron,thanks for the guidelines. I had to look through http://www.cisco.com/application/pdf/en/us/guest/netsol/ns241/c649/ccmigration_09186a00801ea79c.pdf to figure out the exact configuration for QoS over GRE over IPSEC ; the trick is to apply "qos ...
