Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The client has an outside ASA in transparent mode which has the "sysopt connection permit-vpn" enabled, there are also ACL rules to only allow certain outside Internet located routers to create VPNs to the internal ASA.How is it best to log connectio...
I am trying to move a device from the Default location to a sub group and get the following message when I try (either with IE or Firefox)This System Failure occurred: Index : 0, Size: 0. Your changes have not been saved. Click OK to return to the li...
Hi,I have been given the task of sorting out an ACS 5.3 server, the devices were all imported from an older 4.x ACS server. All the devices where placed in the 'Migrated_NDGs' group which was created by the migration tool.Since I have no need for thi...
Hi,A client has had their FWSM fail, when you try to start the module the switch eventually disables the power to that slot (%C6KPWR-SP-4-DISABLED: power to module in slot 4 set off (Module Failed SCP dnld)). I have turned off diagnostics with 'no d...
Hi,I'm having problems getting FTP to work through two FWSM virtual contexts which are connected via a vrf. All this is configured on a 6500 switch with the FWSM running 3.1(4)CLIENT-----CONTEXT_1-------VRF------CONTEXT_2--------FTP_SERVERAt the mome...
Put the FWSM in to multiple context mode and add the vlan interfaces to the relevant context. If you need to route between all the vlans you can use a VRF that has SVIs that inter-connect the FWSM contexts. But make sure you read up about the limitat...
jrabinow,Thanks for the help, it worked well. I had to find where it was referenced in a policy and remove it but after that it work as you suggestedMel
Thanks for the pointers guys, both answers were useful. In the end I exported the troublesome clients to CSV, deleted them and then imported them back. They are now editable via the GUI once again.Our primary ACS was built as a 5.2 and then upgraded ...
