Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I´ve connected several AP1200s connected to a WS-CE500 switch with Smartport Role Wireless configured on the switch.Additionally I´ve configured several VLANs on the APs and the Switch.Everything works fine except Layer2 Roaming between the APs...
Hello,is it possible to establish a LAN-to-LAN VPN between an IOS Router and a PIX using "interface tunnel" on the Router. If it is possible, what should be configured at the PIX. Reason: using dynamic OSPF Routing over simple IPSEC-VPNs without GRE...
I´ve a Callmanager 3.3 on the one side and a Callmanager Express on the other side.I´ve configured a Intercluster Trunk between both systems as it is described in the Callmanager Express System Administration Guide.When I start a call from a phone co...
Hello community,I´m running a Cisco 2811 with Callmanager Express 3.4 and VIC2-2BRI-NT/TE.On outbound calls at the called Party in PSTN has only displayed the Main Telephone-Number and not the calling partys Directory-Number.e.g. the Main Number is ...
Is it possible to integrate 3rd party products like HP Procurve Switches into Cisco Works LMS 2.5.If yes, what kind of management is possible with this integrated products?I suppose it is depending on the MIB.What is your experience about what is pos...
Hi Rob,I´m using a BRI not PRI but anyway this shouldn´t matter.example:interface BRI 0/0 isdn map address 123435.* plan isdn type national123435 is the your own main telephone-number and * the wildcard for any following DN.saludosGeri
I don´t think that´s a problem with the provider. Because when I connect a traditional PBX of e.g. Siemens to the BRIs, it works as it should. Greetings,Gerald
hello Mehmet,thanks for your response.yes this is an euro-isdn connectivity.setting the plan to isdn and the type to national did not solve the problem.sending only the last two digits didn´t either.Thanx,Geri
In this case it can´t be the case because this happens after a reload of the router with no traffic passing it.Meanwhile I found that this is a Bug in IOS: CSCee59549
