Folks, greetings. I have the following scenario: A users network (10.0.0.0/24) trying to connect to a pair of web servers on 192.168.1.0/24 network. I am trying to load-balance using N9k (ITD) with the version 7.0(3)I4(2) in mode vPC. The configurati...

Hi.I have a curiosity.. would it be able to me response on which platform linux work the wireless location?Regards,

Hi, I Have several subinterfaces configured in GSR closing the connection L3 in some BRAS (connection point-to-point). But after everything configured with itself ping in some interfaces and other no. Did some already catch this problem, will it be t...

We have a wlc 4402 (IOS 4.1.185.0) with a few LAP1131 associated to it.All the APs are located in different cities (one per city) and every AP is connected to a trunked Fa0 of an 877 router, that provides to the APs its IP address as well as the IP a...

Hi guys, I know that the interface fastethernet of SCE supports only an address IP for the ports MNG1 and MNG2. However, I would like to know if the possibility exists of addressing each port MGN individually.TksLeandro Nunes