Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,yesterday I've added my core switch (WS-C4507R+E) to our Cisco Prime infrastructure server to perform some tests. This morning I've noticed that many vty sessions have been opened by the Prime server and I was trying to close them but I'm not ...
Hi,I've a strange command output on a catalyst blade HP 3120 about the output drops. When I issue the command show interface I see the following:SWNCL6#sh int g2/0/2GigabitEthernet2/0/2 is up, line protocol is up (connected) Hardware is Gigabit Eth...
Hi everybody,I've got two cat 6509 in VSS mode and the at the moment the secondary one is shutted down because I'm replacing a line card (WS-X6708-10G-3C) on it.My question is about the (probable) loss of service that can be caused when I'll power on...
Hi,I've got a stack of 2 new Catalyst 3750 V2 48 ports PoE.All the ports are configured to support ip phones + pc (switchport access vlan X + switchport voice vlan Y)My problem is if I connect one or more Ip Phone model 7960G tey're not powered by th...
Hi,I've deployed a wireless bridge using 2 Aironet Bridge 1310, configured with 4 sub-interfaces to carry 4 Vlans over the radio bridge.The native VLAN is the VLAN 1, it's rightly configured on the trunk interfaces but I cannot ping the directly conn...
I give the command: show int g2/0/2and I have the following value about the total output dropsTotal output drops: 3499518407I repeat the command after 3 seconds:Total output drops: 37576If I had a problems on the interface I should see the first valu...
The steps that I've performed are the following:* update of the new WLC to the 5.2 version (same of the primary WLC)* download to the controller of the previously saved configuration* All the parameters are ok but the security, in fact I've lost the ...
I had your same problem.After many tests I fixed the situation configuring all the AP's on one WLC and keeping the second one in standby (empty but ready to accept registration if the first fail).You can configure the order of the WLC's on each AP.Re...
