Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I started using RTMT Email Messages to stay up to date on Critical Alerts and keep getting the Cisco Certificate Enrollment Service is down. Does anyone have any ideas on how that can be resolved?Thanks!
We have been having issues with our PRI. All outgoing and incoming calls are getting busy signal. I have a ticket open with Cisco TAC but it seems like we are stuck. We have a Cisco ISR4331 with a Serial Card for the PRI/T1 but the phones were wor...
Hello,I am reaching out looking for help with trying to reboot or start up VMs that are running on a UCS Server. We had a failed hard drive and had to install the new one, but we cannot access to webpage at the IP. I can ping it and SSH into it but...
Status Update - After hours and hours of testing and looking at logs we had the provider/carrier perform an intrusion test. After that, they realized that their E5 switch failed and needed to replace 2 cards. (We found this out on Wednesday - 1PM P...
Roger, this is what I see:Global ISDN Switchtype = primary-4ess%Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not applyISDN Serial0/1/0:23 interfacedsl 0, interface ISDN Switchtype = primary-niL2 Protocol = Q.921 0x0000 L3 Pr...
Thank you but before they were poking around we did get a fast busy signal when we tried to call out. Now we get, "The call cannot be dialed. Please consult your directory and dial again." show isdn status = Layer 1 ACTIVE - Layer 2 AWAITING_ESTAB...
Okay,Status Update: We are still down. I have talked with the carrier and they confirmed that testing shows everything is good all the way up to our end. We swapped out the Serial Card on the 4331 Gateway and still nothing.I have been thinking abou...
