Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We upgraded CER to 10.5.1.10000-5 so it would support our new 3650 switch stacks. CER is discovering some of these new switches and others we are getting an error mess stating that the device is not supported. All switches are running version 03.03.0...
We are migrating from a Cisco 7304 to a ASR 1002-X for our Internet router. Previously in the 7304 we used a BVI with our primary and redundant physical interfaces that connected to our service provider. Spanning tree was used on the physical interfa...
We are attempting to get Microsoft's Network Load Balancer to work for our environment. I have read http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080a07203.shtml, but our environment differs in a couple of...
I am configuring a PIX 506e for implementation on a network. The inside network consists of about 25 combined workstations and servers with an IP addressing scheme of 10.x.x.0/24. Some servers need certain TCP or UDP ports translated publicly for eac...
I am new to CiscoWorks. I am trying to configure RME to manage the software on 2900XL/3500XL switches. It appears that I have to delete the current image on the switch or the job creation fails when I get to the "Verify Image Upgrade" page and I get ...
We never saw any of these issues when this was implemented for our Internet connections. Spanning tree always had one interface forwarding and the other blocked. We never had any retran or multicast issue.
We have since moved away from this configuration with a new service provider but I had the service provider at that time tag a vlan 100 on their side and configured our side as shown below.
bridge-domain 100
!
bridge irb
!
!
interface TenGigabitEthe...
We rolled back to version 3.3.3SE and it fixed the problem. We tried 3.3.5SE but it seems to have the same bug. We only saw this issue with stacks. Single switches were fine.
