Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a question about a design change in our network. We currently manage our PE and CE routers and run vrf-lite on our CE routers with a T-1 connecting to the PE routers with frame-relay so we can make each subinterface a member of a differ...
Hello,I am trying to filter LDP label bindings to only advertise my loopbackaddress(for vpnv4 traffic) but I am unsure as to what the requirements are.Here is what I have:PE1#show ip route connected | in ^CC 1.1.1.0 is directly connected, Seria...
Hello, I am trying to understand the following. I have a PE(7200-SF02) router peering with 10 other PE routers and one E-BGP, all these routers are sending a default route to each other, but this router only shows 2 learned routes in the RIB-IN:7200-...
Hello,The last month or so we have had some issues with our 7200. All theprotocols(LDP,OSPF,sometimes BGP) appear to bounce with dead timersand the CPU goes up to 100%, weird thing is that it happens during off-peak hours (Sunday, early morning weekd...
Hello, I am trying to find an OID that keeps track of SIP calls in a voice gateway. Does anyone know of one? Any suggestions on how to track active calls besides snmp?
They will not be stored into memory if the RT does not match, so thats not relevant in this case. Any other reason not to extend MBGP/MPLS to the CE router?
1. are you sure all of them are received? let me simplify. If I have 2 PE routers and they only share 1 vrf, they will discard routes that do not match that VRF. There is an implied automatic route-filter based on the route target:http://www.cisco.co...
thanks for your reply Giuseppe. "enabling MP BGP on the CE can have a huge impact without filtering." Can you emphasize on this a bit?My understanding is that MBGP will not install the route in its BGP database unless it has a matching route-target i...
wouldn't a simple "show mpls forwarding-table" do it?7200-SF04#show mpls forwarding-table labels 52Local Outgoing Prefix Bytes tag Outgoing Next Hop tag tag or VC or Tunnel Id switched interface 52 Un...
Ok nm, I guess is the only way to pass a label. It is a bit confusing since the full database ospf shows up on the opposite side when the sham-link comes up, but nothing works since no tags are imposed.
