Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to implement WLAN QoS. WLC 2504 8.2 is configured as shown below.
ICMP packets are marked with DSCP 18 however I don't see them on the switch interfaces.
Interfaces do trust in both DSCP/CoS.
What's wrong?
Thanks,
Istvan
Hello Everyone,
I have a trial version of Cisco ISE 2.0 and so far I did not find any option to log the guest users in using their Facebook, Twitter or any other social media accounts. I am wondering, because we use Huawei's NAC solution so called A...
Hello,
Assuming that "Air Time Fairness" is on, how can I calculate the real bandwidth per AP per channel?
Let's say we are on 5Ghz. Channel for N is set to 40Mhz, for AC is set to 80Mhz. GI is set to short.
4 clients are associated at 877.5Mb/s, ...
Hello,I have a laptop running Ekahau site survey, Inssider and windows powershell command netsh wlan show interface. Ekahau and Inssider tells me the RSSI level is -43dbm. Windows power shell command output tells me 84%.I have found the formula to co...
Hello, I am using a ASAv. It has an inside interface. On the same subnet I have a management station. (ASA inside int and the laptop are on the same subnet) Behind the ASA's inside int there is a router. It has subnets behind. I can ping the subnets ...
Hello Alex,
Can you please take a look here?
I have a question about designing an indoor wlan using only few AP's and splitters+external antennas. Thank you!
https://supportforums.cisco.com/discussion/12926026/3x3-mimo-huge-cell-design-using-splitte...
Hello,
I have a theory.
Let's assume that max 5G rate may be 1300Mb/s and 2.4 may be 216.7Mb/s.
In this case the real BW would be 650Mb/s and 108Mb/s respectively.
So the max BW what AP would require may be 758Mb/s when the clients are associated ...
