Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cisco Catalyst 4510R+E Switch and we want to install 10 Gigabit Ethernet port slots on it. We want to know that how many number of slots can de added to the switch with maximum number of 10 Gigabit Ethernet ports per slot. And what can be t...
Hello everyone,
Today we have installed a new Cisco 2960-X 48 ports switch in our data center and during configuration we observed that when we were using interface range gig 1/0/1 - 48 command to configure all interface in one time the switch got ...
Hello Everyone,
today i got a new 2960-X series 48 port POE switch for new business requirement and i just copied new IOS(c2960x-universalk9-mz.152-6.E2.bin) file in flash, after that boot that switch with this image but during the reboot or post i...
Hello Experts,
I hope you all are doing great.
We have a Ntp server in a customer local network and we want to sync that Ntp server with Global Ntp server, the Ntp traffic will traverse through the Cisco ASA, So i just want to know what is the Be...
Hello All,
We have two running cisco 4510R+E switches as a Core and HSRP is running in between them, earlier we had upgraded the switches IOS with IOS XE 3.8xx release and after upgrading that, everything was good but whenever i am checking logs, s...
Thanks Marvin,This is the only confusion i have if anyone maliciously attack on our trusted local Ntp server, So i could we save our trusted Ntp server.i am looking forward that best practice or workaround.
