Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, From 2012, I was following the thumb rule of maximum 50 routers in an area for My OSPF network ( which consists of more than 500 routers and 15 areas). At that time, the major number of routers were 1800, 2800, 3800 series. But now network is hav...
Hi,
I am trying to connect 2 3560X-24T switches using single strand bidirectional fiber with GOXS-BI5312-20D SFP module. the sfp is third party, and it is not working. the interface is not coming up also.
Any one have any idea how to make it working...
I am trying to configure acl in a cisco sg500x switch, and to apply tge acl binding on vlan interface. But to my surprise, the service-acl command is not working under vlan interfaces. But in the command reference guide on sg500, it is mentioned that...
Hi more over a solution, atleast I found that the fault is with module, and sorry for the delay in response.. This much time took to replace the faulty module...
Hi,I will suggest to split the network into two parts. 1. Server 2. Usersstacked or L-3 HSRP & L-2 port channel switches can be used for connecting servers. in the case of W2k12 servers, either you have to work with hardware team for installing an ad...
