Hi,I received the below message from the RTMT for which I am unable to find alot of information. Common sense points me to a network connectivity issue but there is none. Can someone guide me to the right resources or tell me what would be causing su...
I am trying to enable rate-limiting on a Gig Port(GBIC) on the 4500's. I have a customer connected via fiber but I only have to provide him with 1 vlan and 10MB of bandwidth. What is the best way to do this?Thanks,Jeet
I have a PIX 515 v6.3(5) at hub site 'Sudbury'. Have another branch site 'Edmonton' that connects to the hub on the outside via a VPN. Now we have setup a VPN tunnel between Sudbury and Ohio. (Ohio is a client site and has a server that my company ne...
Hi,I have a customer who is sending me a network with a prefix of /20 and I am also learing the same network with a prefix of /22 from one of my IX peers.So if any one on my network wants to get to the customers network it uses the IX peer as the nex...
Is anybody aware as to wether the command "ip verify unicast reverse-path" works for interfaces in VRF's.And if yes, do I need to tweak the command in anyway.Thanks,J. Bhatia
2-Servers; 1 publisher and 1 subscriber. I got the same error in both servers a day apart.Also both servers are connected to the same switch with no congestion, hence I know there is connectivity between them
This is gig port with a GBIC and it only does 1000. You cannot change the speed to 10 or 100 on these ports. I was hinting more towards some kind of service policies. Its not totally clear to me how it can be done at L2, any help will be appreciated....
You need to add the following command to your PIX firewall:fixup protocol pptp 1723Refer to the link below for the reason you need to put this in.http://www.cisco.com/en/US/customer/products/hw/vpndevc/ps2030/products_configuration_example09186a00800...
