Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a router which learns a subnet via ibgp (preferred) but also has a floating static route with AD 220 (static route is not redistributed to BGP). When primary path fails, floating static route gets installed on routing table as expected. But wh...
Is it possible to create GRE tunnel inside GRE tunnel where both tunnel terminated at a single spoke router?1st GRE Tunnel is basically a mechanism to get to the 2nd tunnel termination router (static route pointing at 1st tu termination router as nex...
We have two geographically separated datacenter. Our primary data center has a vpn headend device that many external organization connects to (IPsec S2S vpn). We would like to set up DR vpn headend device in our backup data center. Now the problem is...
We had one VPN concentrator (3000 ip 170.48.29.xx) in our main datacenter, currently we are establishing a second data center in another city, we will have an ASA (ip 69.87.39.xx) as VPN concentrator for the 2nd data center. All our users (S2s, vpn c...
I am currently working on a migration project. We have two LANs running parrallal during the migration, one 192.168.1.0 and the new 10.1.1.0. Now I have a user (10.1.1.6) needs to access a server (192.168.1.7) on the other LAN. No other inter lan acc...
Is there any way to configure switchport port-security in an automated way? I dont think it is efficient to configure 300 switches manually. So I am looking for an intelligent solution to cofigure all switches with port security excluding switch port...
SW4#show interface fa 0/14FastEthernet0/14 is up, line protocol is up (connected) Hardware is Fast Ethernet, address is 0019.55db.b70e (bia 0019.55db.b70e) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload ...
