Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having a tough time getting a VPN Tunnel to work and I've built these before. But, this is a scenario I have not been in. I have two sites that are already connected with MPLS. We want to run a new subnet across the internet on a VPN tunnel for b...
I have a 3750 that goes to it's normal internet connection. I have a dsl plugged into a layer 3 switchport on the 3750 and would like to send on address request to it... let's say google.com at 216.239.32.20. I was going to use route-maps but the ipb...
I have a 3750 stack with several vlans and svi's. We have had no need to route between them until now. Here is what I have done...Created the vlans.. vlan 1 and vlan 25Given each vlan an ip address vlan 1 10.0.0.2 and vlan 25 is 192.168.5.250no shut ...
I have a device that does ip audio on one mac address and managagement is on another mac address. Both of these mac addresses come from one NIC on the device. We need to split these two traffic paths into two different vlans.How can I program this sw...
That was a frustrating day! That's why I posted this hoping to save someone the headache I went through. Glad it helped you. In my case, it was Meraki AP's causing the issue and I couldn't just disconnect them. They ended up using a different port an...
Yes. The ip addresses you have on the 2960x are to login the switch. Do not use duplicate ip addresses anywhere. The ip addresses on the router will be the addresses used as the gateways and to access the router simultaneously (if not blocked).
Look ...
I know this is old but there are many of the same features available in a 2960x as the less expensive SMB switches like the sg300 series switches. This depends on your data requirements of course. Just because it's remote doesn't mean it's small or h...
I know this is old but I recently learned this command. Try it out. It shows the mac address of the interface, not what's attached.
show interfaces | i (.* line protocol is )|(.* address is)
I made it so I could run the clear xlate and the commands for this fast enough the device couldn't rewrite it. Here's what I did for mine. I added clear xlate every other line. I opened ASDM then went to tools, chose command line. I selected multiple...
