Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Distributed a static route from another router. The router with the problem shows the following, some of the routers are able to install the same routes successfully. Router#sh ip ospf database external 7.7.7.0OSPF Router with ID (10.10.1.5) (Process...
anyone using it ? Followed the guide fromhttps://github.com/ios-xr/bgpfs2acl A bit confusing especially i have almost no knowledge on docker commands. Managed to clear step 2. At step 3, when running "source run_container.sh"It seems like the docker ...
Supported for NCs-5501-SE? Found this from ->https://www.cisco.com/c/en/us/td/docs/iosxr/ncs5500/ip-addresses/65x/b-ip-addresses-cg-ncs5500-65x/b-ip-addresses-cg-ncs5500-65x_chapter_0111.html However, while inside GRE tunnel configuration (tunnel-ip...
In the setup, there will be 2 x BGP routers capable of doing up to 400g routing (non-cisco) and 2 more BGP cisco routers capable of doing multiple 10g routing. In day to day operation, definitely, there won't be such a crazy amount of traffic. Just f...
In the setup, there will be 2 x BGP routers capable of doing up to 400g routing (non-cisco) and 2 more BGP cisco routers capable of doing multiple 10g routing. In day to day operation, definitely, there won't be such a crazy amount of traffic. Just f...
Hi Paul, they are all type 5 advertisments. My guess is , it could be due to BGP?(In the far end, i have a juniper router which i redistributed static into ospf) In fact, i'm running BGP and this path is available via eBGP. I would like to have this ...
It will say this method works the best. By selectively leaking routes into nexus routing table to steer traffic into the selected routers. In a network, the well known 80/20 rules applies. 80% of the traffic will typically comes from a few AS number...
