cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1117
Views
10
Helpful
4
Replies

IPv4 ABF nexthops routed over GRE interfaces are supported?

kinwai
Level 1
Level 1

Supported for NCs-5501-SE?

 

 

Found this from ->

https://www.cisco.com/c/en/us/td/docs/iosxr/ncs5500/ip-addresses/65x/b-ip-addresses-cg-ncs5500-65x/b-ip-addresses-cg-ncs5500-65x_chapter_0111.html

 

However, while inside GRE tunnel configuration (tunnel-ip) , there's no option for

ipv4 access-group 

 

1 Accepted Solution

Accepted Solutions

Hi,

 

pbr on gre, that may not work on this router.  you may have to do something "creative".

such as connect port 1 and port 2 together, have GRE traffic exit port 1, put ABF on port 2 to route to next hop.

something like this.

 

maybe someone else reading these posts may have a better idea.

 

Thanks

 

View solution in original post

4 Replies 4

tkarnani
Cisco Employee
Cisco Employee

Hi,

 

the packet comes in on a physical interface, hits the ABF and is routed out a GRE tunnel.

this is what is supported on the NCS5500, not abf inside GRE tunnel interface


Thanks

 

my requirement is to "policy route" the traffic sourced from GRE tunnel to specific outgoing next hop. In this case, i suppose it is not supported ?

Hi,

 

pbr on gre, that may not work on this router.  you may have to do something "creative".

such as connect port 1 and port 2 together, have GRE traffic exit port 1, put ABF on port 2 to route to next hop.

something like this.

 

maybe someone else reading these posts may have a better idea.

 

Thanks

 

this router have too many limitations.