Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are getting 2 Cisco CBS350-12XS switches and want to stack them over the available 2 x 10 Gigabit copper ports. Can someone guide whether it is possible to stack over these copper ports?Since these are shared ports, can we configure stacking...
Hello All,
We have flat VLAN1 network and are facing issue with broadcast traffic on a particular switch. We have Cisco switch with below details,
Model: WS-2960-48TT-L
SW Version: 12.2(25)SEE4
SW Image: C2960-LANBASEK9-M
The ports on this switch a...
Hi,I have Cisco ASA 5520 / ASA Ver: 8.0(4) / ASDM Ver: 6.1(3). I have configured Remote Access VPN and everything seems to be fine. Like i have created Extended ACL and allowed for singe host with particlar port to be allowed.After login with the Any...
Hi,I am trying to configure Remote Access VPN in our Cicco ASA 5520 firewall through SSL VPN wizard. I tried to configure Anyconnect VPN client option, but after entering user/pass it gives error "An error was received from the secure gateway in resp...
Hi,I want to create a local user in my Cisco ASA 5520 to allow the user to use the ASDM in Read-Only mode. I want the user to view the Dashboard only.Can somone guide me with the confuguration ?Thanks,K
Hello Marce,Thanks for the useful link. I had gone through the link and one of the statement mentioned in it says, "The uplink network ports will be configured for stacking and the proper interconnecting small form-factor pluggable (SFP) cables suppo...
Hello Georg,
Thanks for the reply.
The command "show controllers ethernet-controller" is very informative. I am not very good with the numbers i see in the output, but would try to figure out the ones' with the maximum broadcast frames and focus on...
Hi Jouni,I tried the Option1 and it is working fine as required.Is there anyway to allow access only on particular computer and not from multiple computers ? Can one user login with more than single session ?Thanks,K
Hello Jouni,Thanks for reply.I have done the changes as per option2. After connection, when i see the details of the user session in the asa, i can see that the acl is applied as per the selection, but on the user's computer i am not able to access a...
