Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to upgrade our three WLC 4402 controllers from version 7.0.116.0 to 7.0.235.3. I have downloaded the two files (AIR-WLC4400-K9-7-0-235-3-ER.aes and AIR-WLC4400-K9-7-0-235-3.aes). Which one should I upgrade/install first? I haven't ...
Hello,is there a way to monitor configuration changes in ACS 5.x. I would like to have a report or a message, when the configuration has changed (e.g. rules, policy elements, new hosts ....).Thanks in advance.Kind regards,Michael
Hello,when I sent the "show arp" command on an FWSM I get the ARP table. The ARP table contains some strange entries. Is there a way to get a normal arp table without any substitutions (like the arp table on any switch), which contains only the inter...
Hi,I've a question regarding the interface speed from a vlan interface. From which physical interface / module is the interface speed inherited? When I submit the "show interface vlan id" command on our 6509 Sup32 it shows the speed of: BW 1000000 Kb...
Is there a way to display all the switch interfaces which have not configured port security? I would like to make sure that all ports have the same port security configuration.
@Krasnoperov:Have you found a solution for your problem? I would like to see all the ports which have no 802.1x authentication enabled too. But unfortunately I have no idea how to do this.
