Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!We have WLC 2504(airos 8.5.130 ) with mix of AP1832 and AP1702I. Clients report sometimes slow performance and lags.I start test today - sit in direct AP vision and start ping controller and gw. I see same issue. Delay jump from 2ms to 80 -150...
Good day everyone. I faced with strange issue. My IPSEC tunnel won't initialise.My initial data are following:1. HQ ASA 5515 - 9.8(2)38 Security Plus license2. BO ASA 5510 - 9.1(7)32 Base licenseOn both sides I configured L2L IPSEC VPN. Both sides ha...
Good day,
does somebody know how to(or whre) download IOS that EOL ?
I need IOS for WS-C3550-48-EMI lates that I found on download portal is c3550-ipservicesk9-mz.122-55.SE12.bin. When I try download it I get error that file is not available. Any su...
Good day All.Have troubles with multiple tunnels.I have following application:My topology is hub and spoke. On hub router I configures RA-VPN, l2tp and GRE tunnel with ipsec.My remote peer is behind NAT. I cannot make it work. It connects to hub rout...
Hello All!I have installed LMS. Then I have configured Default Credentional Set. Then start discovery with cdp and arp modules. LMS found my devices, 2 of them are reachable but other unreacheble. All snmp settings on the devices are the same. I tes...
You should check1. That local rules(on PCs) are allow connection2. That all VPN Netwroks are in split acl(If you have split tunnel)3. No DAP policy that prevents this traffic.4. Same interface traffic permit(same-security-traffic permit intra-interfa...
Suppose Cristian is right.But not sure about nat zone.I suppose this should worknat (inside,any) source static NETWORK_OBJ_10.144.116.48_28 NETWORK_OBJ_10.144.116.48_28 destination static vpn-subnet vpn-subnet no-proxy-arp route-lookup
