Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Catalyst Switch that is been used as a SAN switch providing ISCSI connection for servers.The total output drops of the interfaces connected to the SAN and some connected to the servers keep increasing.Example below:SWESAN1-1#sh interfaces gi...
Hi All,I'm investigating an issue in our network where we get some packet loss accross our Man link. The Man is formed by two interfaces in each switch forming a etherchannel set to LACP in active mode.I noticed that SWE2-1 has one interface media 10...
Hi all,I was just brushing up few things in GNS3 and after setting up an SLAip sla 1 icmp-echo 192.168.200.1 timeout 1000 frequency 6ip sla schedule 1 life forever start-time nowNow when I want to set the track ip I get not option for sla why???Rout...
Hi There,I'm trying to set up a IPSEC VPN connection in my GNS3 lab and all the show commands and debugs does not seem to give me any clues of what is wrong or missing...can someone please help me in troubleshooting my VPN config. Below is the config...
2000+ routers are a lot of routers to be pluging console cable....To be honest I don't know if this will work but here it's:Try to write or modify an EEM script such as this one https://supportforums.cisco.com/thread/2139927 with the instructions of...
1.) Make sure vlan 40 is created "sh vlan" if not go to Global config mode and type "vlan 40" press enter "name ILO_Access"2.) communication between server and switch in your case has to be done by switch in access mode so go to the interface fasteth...
This has been covered before. Please take a look at https://supportforums.cisco.com/thread/2155657On top of that you have statically configured the port in access mode and the other is in dynamic disarable mode. it shouldn't make any difference but I...
Hey,Your problem may be related to your routing table.Looking at the config of the router 1811 you have "ip route 0.0.0.0 0.0.0.0 141.0.59.x" which is correct for internet traffic.Try pinging a public IP using the internal interface as source like:"p...
Hi Joseph,Thanks for the post. It's a dedicated SAN switch, other than the management vlan there is nothing else. There is no QOS the switch is doing FIFO.Joseph at the moment we only have storm-controlI set on the interfaces restricting broadcast tr...
