I was reviewing the configuration a new ASA5505 running 8.0 and I saw the following statement in the configuaration: dynamic-access-policy-record DfltAccessPolicyNot knowing what the command does, I tried to remove it but an error stating I am not pe...
I have a Cisco 7500 with a single RSP4. I would like to take out the RSP4 and place a Master and Slave RSP8 in its place. My plan of action was the following:1. Place the RSP8 in the slave slot.2. Wr mem on the Master RSP4 This should transfer the ...
I configured a PIX 506E with two internal vlans. One vlan is called DMZ and the other is called vlan4. I want a device on vlan DMZ to ping a device on vlan4. In order to make this possible, I needed to create an access. However, I can not get my ...
Hi,I've purchased a Cisco ASA5510. I currently have 3 of the 4 licensed interfaces being used. My third port on the ASA is configured as the internal interface. I would like to have the 4th port set up to be an internal interface too. This would ...
Please include the configuation on the multilink interface. The output should be something like:interface Multilink4ip address xxx.xxx.xxx....ppp multilinkppp multilink group 4
Jose,Sundar gave you the correct answer above.ine vty 0 4 (This command allows 5 active telent sessions).pass cisco (local password to the vty group).login (optional but the default username is admin)enable password cisco (This is to set the enable...
I'm guessing your question is whether MST works with 3rd party switch vendors?I found a Cisco document while back that states "Most non-Cisco 802.1q switches maintain only a single instance of spanning tree, known as Mono Spanning Tree (MST)." You ma...
