Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was looking for guidance or decent documentation on how to get a windows xp or 7 machine to authenticate via 802.1x to our wireless and login into our domain in a single step.We currently have wireless clients login to a local workgroup and then au...
We are trying to setup 2 Nokia FWs in a High Availibility setup. Active/standby is are setup. When the active fails we are hoping for a stateful failover to the standby FW. Instead we are getting the following messages on the switch.2006 Nov 26 11:44...
I have connections to 2 ISPs terminated on a single router taking full routes.ISP A- T3 address block xx.xx.xx.xxISP B- 2xT1 advertises the same blockI have set the local preference to 500 for ISP A.I have also prepended our AS for our route advertis...
I have a CAT 4006 sup III running 12.1(11b)EW1 with a number of servers attached. Users started having problems accessing servers. After investigating all the impacted servers were connected to the same switch. The switch was appeared to be operating...
I am connected to two tier 1 ISP's and take full routes from both. I have a T3 to one and dual T1's to the other. The dual T1's are intended to be a backup to the T3. I have local-pref set to 200 for all routes learned via the T3 ISP. I also am prepe...
I have 2 hosts plugged into the same switch. They have there own MAC addresses and use a virtual MAC to provide failover. What I have in the DYN CAM on the switch is one port with real MAC and one port with both its real and the virtual MAC. The virt...
I believe that if the destination mac is not in the cam table of the switch that the unicast traffic is broadcast until the switch determines the mac and updates its cam table. For more info search the Cisco site for "unicast flooding".If you review ...
A basic overview of their use is as follows.On a content switch you configure a virtual host address and port for your application. Then you assign real server addresses to the virtual address in your configuration. Add a DNS entry for your virtual a...
