Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi is it possible to see up and down link speeds on 819G or 897G when they're connected to mobile network for 3G/4G? In 880 series, the 'sho cell 0 all' used to show "Uplink Max" and "Downlink Max" Mbps speeds. This output is not available on 819G or...
hi - we have an ASR 1002 configured to be an LNS: when we use the following RADIUS AV Pairs:cisco-avpair="ip:ip-unnumbered=Loopback 13",orcisco-avpair="lcp:interface-config=ip address 16.16.45.41 255.255.255.252", We get the following message and the...
Hi - is there a way of finding out what AS number an EBGP peer is using to peer with my router? Obviously do a debug and reset the BGP peers, but I wondered if there's any 'show' command which can show me the same thing?Note - I don't mean the neighb...
Is there a MIB which would give nice output suitable for populating a hardware network inventory?We're looking for the MIB we could use to put in a script which would give us chassis, flash, linecards and power supply per Cisco device...Thanks in adv...
I'd like to configure an 837 running 12.3(11)YZ ip plus for IPSec passthrough. Is there a configuration guide available on CCO? I can only see sample configs for doing this on a PIX... thanks - all help greatly appreciated!
Hi - thanks but I'm trying to find out the AS number of my own router that they're peering with. I have subconfederation configured: if I did a debug on BGP and reset the peers then I think we'd see it with the OPEN BGP message, is there another way ...
Hi - I'm actually after finding out my own AS number that they're peering with: my router's part of a subconfederation.I know i'd see this in a debug of the OPEN message when establishing neighbours - I just wondered if there's another way of seeing ...
