Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am trying to write an EEM script for a failed sip condition so for example when the command show sip-us statistics | i ReqTimeout is run if the values increase I am then going to stop a traffic export and write to flash. The latter works fine.Whe...
I have an asa between cucm and phones which is doing skinny inspect. There has been an issue where skinny setup packets are dropped, but the firewall has been retransmitting the lost packets. This has caused cucm to set up the call but there was no ...
Has anyone encountered an issue when adding a jtapi call control group to ipcc 4.0(1) build 002, you go to update and the screen hangs stating it is adding group.
I have had an issue with neatwork eap configured on the AP with Encryption mode wep mandatory. Not all clients could eap authenticate but some could. The rest would only authenticate when the broadcast wep key was entered in slot1. Has anyone else co...
I managed to get 7821's working with fast track approach, but found I had to remove call-feature-uri cfwdall command to be able to set call forward on the phone. Everything else appeared to work ok
Have a look at the following, http://www.cisco.com/warp/public/788/AVVID/jtapi-startup.htmlUnable to create provider -- null - Verify that a host name or IP address is configured in the JTAPI configuration. If the JTAPI version is incorrect, download...
