Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,
we have CME 10.0 running cisco phones and the other site have Avaya office and server running Avaya phones , how can I route call between them.
Best Regards,
Kazim Abbas
Hi All,
we have cisco and HP switches , core is cisco switch but access switches cisco and HP as well. how to enable dhcp snooping between the trunk link of cisco and HP switches.
Regards,
Hello experts,
i have router 2951 and its Lan side too many drops on input queue:
Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full Duplex, 1Gbps, media type is RJ45 output flow-control is XON, input flow-control is XON ARP type: ARP...
Hello Folks,
I am facing one problem in CME 2951 10.0 version. when try to up load the firmware, it reply you need to delete the some entries from Flash first then you can add.
I have 2 options to do this :
1)remove these type of files crashinfo_...
Hello experts,
I need a suggestion. I have a router 2900 series which is connected with ISP and down streem we have switch with modem. It look like this ISP---- router ----switch SFP -- modem with fiber wan port. The modem is huwaie using in ...
Hello, Normally if you have all correct configuration then, check Java version compatibility , secondly go to internet options >security>trusted sites>sites>IP ADD (ASA). Hope this will solve your Problem! Kazim Abbas
Hello, Normally if you have all correct configuration then, check Java version compatibility , secondly go to internet options >security>trusted sites>sites>IP ADD (ASA). Hope this will solve your Problem! Kazim Abbas
Hi Adarsh,
thanks for your help. I tried the above as you mentioned but connection refused by avaya. I am using codec G711alaw. but ip reach-ability end to end is ok.
regards,
Kazim Abbas
