12-31-2016 10:42 PM - edited 03-17-2019 09:04 AM
Hello experts,
we have CME 10.0 running cisco phones and the other site have Avaya office and server running Avaya phones , how can I route call between them.
Best Regards,
Kazim Abbas
01-01-2017 08:53 AM
Hi,
You will have to get some kind of IP connectivity between two site and then make a dial-peer on CME pointing to the IP of the Avaya Server.
Example.
dial-peer voice 1 voip
destination-pattern <avaya extension generic pattern>
session protocol sipv2
session target ipv4:<IP of the Avaya server>
dtmf-relay rtp-nte sip-notify <DTMF capabilities>
voice-class codec 1
Please rate and mark correct if helpful
Regards,
Adarsh Chauhan
03-19-2017 09:51 PM
Hi Adarsh,
thanks for your help. I tried the above as you mentioned but connection refused by avaya. I am using codec G711alaw. but ip reach-ability end to end is ok.
regards,
Kazim Abbas
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide