Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
How can I configure a soft key on Cisco 9951 for my below requirement:
When any (internal or external) call is ringing on Cisco 9951 IP phone, I should be able to press a key to reject or decline that particular call on Call Manager Express 10.5....
Hi Experts,We have recently installed CUCM 9.1.2/IM & Presence 9.1.1 and tried to upgrade to 11.5 in our lab. Upgrade was successful for CUCM and IM & Presence to 11.5.1.13900-52 and 11.5.1.13900-57 respectively.After upgrade I am able to login to CU...
Hi,anyone had a DTMF digits dialing issue on Cisco 8831 conference phone. If I have to join any external conference bridge, when I trying dial my user id and password its not sending the digit i am dialing. Conference bridge is saying wrong PIN dial...
"Error init: ID "SD0" respawning too fast: disabled for 5 min"I have faced this problem too, after fresh install of CUCM 9.1.2 on ESXi 6.0 on HP DL380 server. Any solution or workaround found ? your help would be great.
Hi Alok,sorry for the delayed reply.I tried CUCM password for login, but no luck.Attached is the error occured on CLI of IM & Presence, when tried to reset UI administrator password.Command entered:utils reset_application_ui_administrator_password I ...
Hi,In my case I have upgraded IM/P 9.1 to 11.5. After upgrade I am not able to login in IM & Presence Administration page, before upgrade I were able to login using same credentials.If I enter username and password it is giving me error "Log on faile...
