Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I currently need to change my Cisco email address from company to personal has I no longer want to associate with.I see on a lot of community posts that this is a common issue on users and I don't understand how Cisco does not take any actions to...
Hi Community, We have a l2vpn setup on XR-OS with two tengig interfaces on the same router joined in one bridge-domain with BVI interface for routing. The setup is working fine, however randomly we get an issue where one of the servers in one of the ...
Hi Community, We are implementing EPNM monitoring on our network and facing some small issues regarding NCS platform BGP monitoring. Not sure if the issue is from NCS side or from EPNM BGP traps are coming to EPNM as Generic Traps and not under the B...
Hi Community, We have configured SNMP on a couple of Nexus 9k. All devices are using the same SNMP config. The monitoring system is able to poll all the devices and also generate network map with all active connections, so communication seems ok. Ho...
Hi Community, I am facing the following log message on an ASR 9010 router running Cisco IOS XR Software, Version 6.4.2 %ROUTING-FIB-3-UPD_MSG_TOO_BIG : attribute ID: 0xB81C, size: 7764, data: 5FFFFFFFF3286C00000002000000000000016B37FFFFFFE57FFFFFFFC8...
Hi Jason, Thanks for your support. At last I enabled the trap "config" which sends a trap if any changes are made to the running-config or startup-config. This allowed to make some simple changes like interface description and a trap was generated su...
Hi Jason,Thanks for the reply. Very helpful commands to check the activity on the switch. In my case, I did a shut/no shut on a not connected interface since this is a setup in production. I am afraid this cannot generate a trap. So I my question is,...
Hi, Thanks for replying. Currently IOS XR Software, Version 6.4.2 is running on this router. And yes 'bgp attribute-download' is enabled on the BGP configuration. BR
Thanks for the reply,
So currently as I have two power supply modules installed on only one shelf, I am left only with redundancy at module level. Lets say one of the modules fails the one left would take all the load right?
Just one question tho...
