About n.t85

n.t85 · 07-13-2024

Hi,I currently need to change my Cisco email address from company to personal has I no longer want to associate with.I see on a lot of community posts that this is a common issue on users and I don't understand how Cisco does not take any actions to...

n.t85 · 05-16-2020

Hi Community, We have a l2vpn setup on XR-OS with two tengig interfaces on the same router joined in one bridge-domain with BVI interface for routing. The setup is working fine, however randomly we get an issue where one of the servers in one of the ...

n.t85 · 05-13-2020

Hi Community, We are implementing EPNM monitoring on our network and facing some small issues regarding NCS platform BGP monitoring. Not sure if the issue is from NCS side or from EPNM BGP traps are coming to EPNM as Generic Traps and not under the B...

n.t85 · 03-25-2020

Hi Community, We have configured SNMP on a couple of Nexus 9k. All devices are using the same SNMP config. The monitoring system is able to poll all the devices and also generate network map with all active connections, so communication seems ok. Ho...

n.t85 · 06-11-2019

Hi Community, I am facing the following log message on an ASR 9010 router running Cisco IOS XR Software, Version 6.4.2 %ROUTING-FIB-3-UPD_MSG_TOO_BIG : attribute ID: 0xB81C, size: 7764, data: 5FFFFFFFF3286C00000002000000000000016B37FFFFFFE57FFFFFFFC8...

n.t85 · 04-02-2020

Hi Jason, Thanks for your support. At last I enabled the trap "config" which sends a trap if any changes are made to the running-config or startup-config. This allowed to make some simple changes like interface description and a trap was generated su...

n.t85 · 03-26-2020

Hi Jason,Thanks for the reply. Very helpful commands to check the activity on the switch. In my case, I did a shut/no shut on a not connected interface since this is a setup in production. I am afraid this cannot generate a trap. So I my question is,...

n.t85 · 06-11-2019

Hi, Thanks for replying. Currently IOS XR Software, Version 6.4.2 is running on this router. And yes 'bgp attribute-download' is enabled on the BGP configuration. BR

n.t85 · 11-19-2018

Yes Exactly what was showing when using the power calculator from Cisco. Thanks,

n.t85 · 11-19-2018

Thanks for the reply, So currently as I have two power supply modules installed on only one shelf, I am left only with redundancy at module level. Lets say one of the modules fails the one left would take all the load right? Just one question tho...

Member Since	‎10-28-2016 02:32 AM
Date Last Visited	‎07-17-2024 01:48 AM
Posts	32
Total Helpful Votes Received	10

User Statistics

User Activity

Change Cisco email address

XR-OS l2vpn ARP issue

NCS5504 issue with EPNM monitoring

Nexus 9000 not generating traps !!

ASR 9010 XR-OS %ROUTING-FIB-3-UPD_MSG_TOO_BIG log

Re: Nexus 9000 not generating traps !!

Re: Nexus 9000 not generating traps !!

Re: ASR 9010 XR-OS %ROUTING-FIB-3-UPD_MSG_TOO_BIG log

Re: ASR9k Power Module Error (PM_NO_INPUT_B_DETECTED).

Re: ASR9k Power Module Error (PM_NO_INPUT_B_DETECTED).