Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a mixed network with a lot of 1700 Series (1700, 1720 & 1721) along with 1841, 1861 & 2800 Series Routers at remote sites that all connect in to our central 3845 Router. We have had to expand our amount of routed networks recently due to ex...
I need some help on troubleshooting a 2811 router that had 2 - T1 DSU/CSU cards in Slots 0 and 1. I replaced them with the following: Slot 0: VIC2-4FXOSlot 1: HWIC-4ESWSlot 2: VIC-4FXS/DIDI can see the 2 Voice cards in Show Version and in Show Diag ...
When working with hundreds of crypto maps and multiple set peers for each I was wondering if there was a way to put any kind of label or remark out beside peers. Most of my entries have static IP's but I still have about a dozen locations that have ...
I have a 2801 router with advanced ip services installed on it (12.4-15T). After rebooting and getting ready to configure I noticed an NVRAM error message:NV_BLOCK_INITFAIL: Unable to initialize the geometry of NVRAMThe recommended action is to redu...
Have a 2801 w/AdvIPServices and 7931 phones. This is my fifth such build out and the only difference that I can see is that I have changed to using ACS.I have CME configured and can see all of the phones showing up in the configuration. I can ping...
I am including the following files:1-Crypto SessionThis was taken while the remote router was up and having the problem.2-Access-ListHere is the full blown access-list for the remote side. When I remove all but the [Host LAN-One] the remote site is ...
I did reset this to factory defaults with no change. And I'm not sure if this helps, but here is another place that it recognizes the cards specifically:Router#sho tech | inc voicevoice service pots voice statistics type csrvoice-card 0-------------...
For about half the price and only a handful of users, this is the way to go. And if you ever need to upgrade the site, you deploy a 2801 and recover this one to use in another small location.They are a little more finicky to configure than the 2800s...
Can you use an IP Phone with this system? Yes. I have several running with them. I think the biggest factor for you is going to be the MPLS. If I am reading everything correctly the only T1 card currently available (that only works with 1861) is ...
