Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a 1710 to do all of the PPPoE stuff. I have set the DSL modem to "bridged" mode and I still have not been able to bring the tunnel up. Here is my config, please help!version 12.2service timestamps debug uptimeservice timestamps log ...
I am attempting to open port 10000 so that I can remotely VPN using tcp port 10000. This is a pix 501 running version 6.3.5.What commands do I need to enter for this to happen?
Hey guys, I was wondering if it would be possible to do prioritization based on IP subnets? I have one subnet for internet access but runs through the same switches as the most important traffic. How could I give priority to the more important subn...
We have a 2811 that has a channelized t1 for voice coming into a controller t1 wic card. We also have a data t1 coming into the same exact type of card. (Both services have a seperate card). We are running IOS version 12.4(12) Advanced IP Services.Se...
I have two 2006 series WLC's and 5 ap's on both. I have a WLAN for public use that has only web authentication for security. (This WLAN has internet only, nothing else. Its used for testing.) When users authenticate, everything works for about an hou...
I took out the ACL's, but they are required so here they are:ip access-list extended acl-crypto-blngmt permit ip 10.10.173.0 0.0.0.255 10.10.186.0 0.0.0.255 permit ip 10.10.173.0 0.0.0.255 10.2.2.0 0.0.0.255 permit ip 10.10.173.0 0.0.0.255 10.4.186.0...
Thank you for that!!! If I wanted to give one subnet 95% of the bandwidth, what would happen to the other subnets?Also, is there a way that I can push this to switches to do qos at their level?
Thanks for the response. I noticed that the statement "network-clock-participate wic 1" command is issued along with "no network-clock-participate wic 0" Here is an update:I reversed the clock roles with my provider. Meaning, I have issued the comman...
