Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I have a question whether I am on right track or not. I have 2 Nexus Switches in vPC. I am planning to configure vPC with the upstream Juniper switches and a vlan 900 will be used on HSRP on both ends. I want to establish eBGP over this v...
Hi,I recently upgraded Cisco ASA 5505 firewall to its latest version 9.2.4 from 8.2 but after upgrade Cisco ASDM is unable to read asa image. Can you please let me know the issue and how it can be resolved. Thanks & kind regards, Muhammad Hamid Ashra...
Hi All,
We have ISE 2.3.0.298 and we are in phase of implementing Self registration Portal for guests with below mentioned flow:
1. Guest connects to guest SSID and redirected to Guest Self Registration Portal.
2. Guest put in First Name, Last Na...
Hi, I am doing a MPLS VPLS lab on eve-ng. Both VC and PW seems to be up but end to end connectivity is not there. Also I am seeing some errors in debug. All details are below:XRV Left: interface Loopback0ipv4 address 1.1.1.1 255.255.255.255!interface...
Hi I am integrating ASR9K with freeradius server for AAA authentication and root-system access. User successfully gets authenticated but unable to configure or see the configuration. Below pasted is my configuration. Can someone help me with this! CO...
Hi @Sergiu.Daniluk I hope you are doing good. Thanks for the response.There is a catch here. I shall not be able to do peering of bgp using SVI because from the peer end the neighbor is my SVI but from my side the source will be the physical or Vlan ...
Hi Balaji, Thanks a lot for the response.I read the article and I can see that L2 and L3 adjacency is supported via vPC peer link and after the introduction of l3 peer router feature l3 adjacencies are possible on vPC peer link. I have attached the s...
Hi Balaji,Thanks for the response. I followed the upgrade from 8.2 to 8.5 and then 9.2. From console it is accessible and configurable. what can be other options other than this?
