Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A sideWS-C6506-E with Supervisor Engine 2T10GBASE-X port B sideN9K-C9336C-FX2QSFP28 port Can I connect these two devices in the same room ?If yes, what optics and cable should be used?
Hi there! We aree in the process of replacing a EOL Cisco Catalyst WS-C4507R-E chassis with three Cisco Catalyst 9300-48P-E stackable Switches. So I would like to know if there is any Cisco tool which can convert the configuration. Appreciate your co...
Hi all,
I have to upgrade the IOS on below switch to s2t54-ipservicesk9-mz.SPA.151-2.SY9.bin.
Most of the cisco forums suggest below steps
Option1
Step1. Copy the new image to bootdisk:
Step2. Change Boot variable using 'boot system; command
Step3....
Hi all,
I am using a controller Cisco 7500 Series Wireless LAN Controller running Software Version 8.0.133.0
Trying to connect a AP cisco AIR-LAP1041N-E-K9 running code C1140-K9W8-M
I get below error, Any help on this is appreciated.
8.0.133.0 rele...
Hi all,
Much appreciate your help on this!!
I normall upgrade/downgrade IOS using command 'software install' which is available in
Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.05SE RELEAS...
Hi Mark, Thanks for the reply.Unfortunately, Catalyst WS-C4507R-E is running IOS 12.2(53)SG. Also I could not find any config convert tool under below link https://www.cisco.com/c/en/us/partners/tools.html Thank you
Hi all,
I have decided to boot from backup software as we are still having client issues with the new software.
We are running WLC in Redundancy - SSO mode. Hence I get attached warning asking me to make sure both active and standby WLCs points to s...
